• Author
    • #15408
      Profile photo of Andrew Normand

      Bendy pencils can be used to make a strain gauge. The pencils come in 2 lengths, 30cm and 200cm.

      Try pound shops – the pencils come in packs of 8 – only 12.5p each. Longer pencils have high resistance and need a good ohmmeter.
    • #15409
      Profile photo of Andrew Normand

      Flexible pencils, which can be bent into many shapes can be used to demonstrate how a resistance strain gauge works. The pencils are made of elastic graphite covered by elastic plastic casing. The graphite is a composite material made of graphite powder and a binding substance. The resistance of the graphite in a 30 cm long pencil is about a dozen k.
      1. Take one flexible pencil. Cut off the rubber mounted in metal together with the sharpened writing end. Then remove 1 cm off half of the plastic outer casing from each end, so that the upper part of the graphite is exposed.
      2. Connect the pencil to an ohmmeter with crocodile clips (make sure it is a good connection) and measure the resistance of graphite in a straight, unbent and non-stressed pencil.
      3. Stretching, bending and compressing the pencil will result in a change of resistance. For all kinds of deformation, except compression, the ohmmeter shows resistance increasing from a dozen to around twenty k. In the case of compression, a decrease of resistance occurs.
      The greater the stress put on the pencil by deformation the greater the level of resistance.
      If the deformation and stress are reduced by straightening the pencil the resistance of
      graphite returns to its initial value.
      Based on an article by
      S Bednarek From Physics
      Education Volume 40 Issue 1
      Themes: Electricity, materials, structures, forces

You must be logged in to reply to this topic.

Log in with your credentials

Forgot your details?